Elkor Web Management Interface

Firmware

WattsOn-Mark II

Detected on Address 1

Connected devices

Gateway

Modbus Activity

Modbus traffic has been detected on the following addresses since boot-up:

Detecting...

Posting status

This device's most recent web post was at the following time:

Elkor Technologies Support

Rebooting Device.

Seconds Remaining

Rebooting

Any changes you made have been applied, and the ETport is now rebooting.

You will be redirected automatically when the reboot has completed in approximately seconds. If the ETport is using a static IP address, you will be automatically redirected to that address.

If you are using DHCP, you may need to determine the IP address your router has assigned the ETport and enter the URL manually.

If you are the network administrator, you can check your router's configuration.
Otherwise, you can do this using the Elkor Finder, a Windows utility available from Elkor's web site.

Network Settings

Elkor Technologies Documentation Support

Card N

You may give a name and a short note to each of the card's three channels to help identify them later.

Card N

Please enter the ratios and any phase compensation values for the current transformers that are being used with each channel.

CT ratios are entered as a colon-separated ratio, such as "100:5" for 100A to 5A CTs. Phase compensation values are entered in hundredths of a degree. They are printed on the labels of some CTs.

	Current Transformers	Phase Compensation
Channel 1:
Channel 2:
Channel 2:

Card N

Please select the voltage channel to pair with each current channel.

Click on a circle to pair a current channel with a voltage channel. The power and power factor for that pairing will be shown; often (but not always) the correct pairing will have the highest values.

Card setup is now complete.

It is recommended that the energy accumulated in all of the cards be reset. This is so that the accumulation on all of the cards begins from the same point in time. In addition, any existing energy accumulation for channels that have been re-mapped to different voltages may no longer be meaningful.

Click the button below to reset the energy. It will take approximately 30 seconds. Communication may be briefly disrupted during this time.

Channel 1
Channel 2
Channel 3
	Voltage A	Voltage B	Voltage C	Disabled